Free version of Dalewj's second book (Diaries of Afterworld) is now available!
unit does it work after a reboot?
I already had C103 installed and when I ran AWS the auto-updated downloaded a small patch, then AWS re-started. Then it downloaded C200 (1 of 9) [see first pic] and when it was done it re-downloaded C200 (1 of 9), then it gave the error message in the second pic below.I tried this several times with the same results each time, so I downloaded the C200 Lite self-installer and ran it. It said AWS was already installed and asked if I wanted to re-install it (which it should just be asking if I want to apply the update), but I clicked OK to keep going and it installed without a hitch. I clicked the box at the end that said "Start AfterWorld Survival after finishing" (paraphrased) and the auto-updater started downloading C201 ( 1 of 8 ), C202 ( 2 of 8 ), C203 ( 3 of 8 ), and so on. After each download it runs an integrity check which is going fine for me so far and I'm currently downloading C206 ( 6 of 8 ).
now using my actual gaming rig..stuck on Please hold onLoading game dataThis can take a whileHard drive setup is SATA2 RAID (0).. After waiting for 5 minutes I killed the game.. turned graphics from Ultra to Minimal and tried again. No luck so farForum shows me being ingame. But in reality stuck on loading screenEDIT: after 4 reinstalls and half a dozen reboots, no change. Can anyone offer some advice?Dual booted into Win8 (Release Preview or whatever version). Same story thereSysinternals ProcessExplorer is reporting IO activity in small amount at first.. it peaks at ~60Mb/s for a short while and then ceases alltogether.. game remains all the time stuck on loading screenScreenshothttp://imageshack.us/photo/my-images/824/survivalissue.png/