AfterWorld Survival Forum

Officials => Tech Forum => Topic started by: Event "Janе" Horizon on October 31, 2014, 10:31:16 pm

Title: C303 - Ctrl D starts but does not finish the revive process
Post by: Event "Janе" Horizon on October 31, 2014, 10:31:16 pm
While in NU, I did a CTRL-D to revive at NU outpost.
The revive process started, the revive progress bar was shown and the world went black.
However, the world stayed black and I was not moved to the NU outpost (i stayed at the ctrl-d location).
I was unable to move and addition ctrl-d's give "Can't call for TravelBot while in current condition." messages.


Relog results in player being in travelbot form.
Ctrl-D blacks out world again without reviving player at NU outpost.


Walked travelbot to NU outpost, entered and was able to reclone myself.
Title: Re: C303 - Ctrl D starts but does not finish the revive process
Post by: Jarod "Brickwit" McBrickerton on November 01, 2014, 04:47:06 am
This is an existing bug from C302 or earlier though I have not experienced it in C303 yet.
Title: Re: C303 - Ctrl D starts but does not finish the revive process
Post by: Old "Snowy" Leopard on November 01, 2014, 09:36:20 am
It is in C303 ... I have already submitted a ticket, and was returned to revive.   I haven't played enough to know if it will happen again.
Title: Re: C303 - Ctrl D starts but does not finish the revive process
Post by: Pila "Pila" Pila on November 20, 2014, 12:09:52 pm
Was out in the northeast part of NU picking, ran into the revive range, CTRL+D , black screen and stayed in same spot. Had to log out.

Logged back in and before the game fully loaded had a Client.exe crash.

Logged in again, i am a noobot (because i revived). And still need to run all the way back into town.

Is this on the fix list for the new update ?